Alaskan Airbus AS350B3e Accident: Botched Autorotation Practice? (N907PL)
On 28 September 2018 a private Airbus Helicopters AS350B3e (H125) N907PL was destroyed in an accident in Glacier Bay National Park, near Lituya Bay, about 60 miles NW of Gustavus, Alaska. One person died, 2 remain missing presumed dead and one was seriously injured.
He had done a AS350B3e factory course in Texas with 3 hours of flight time and 1 hour of simulator time. He had then done 18.3 hours of flying an AS350B2 in Alaska, and another 6 hours on the AS350B3e in Texas, before embarking on the delivery flight from Texas to Alaska.
The trip began on September 25, 2018, and included more than 30 stops for sightseeing, fuel, and rest.
The left seat safety pilot [aged 53, 15,350 flying hours total, 4350 on type, who had flown with the owner for 11.4 hours in an AS350B2 previously] was onboard for insurance coverage purposes and was acting as a safety pilot. The safety pilot was the owner, director of operations, and chief pilot for two different commercial helicopter operators in Alaska that operated several AS350B2 model helicopters.
The NTSB comment that in an interview after the accident the survivor, a 14-year-old boy, stated that…
…the safety pilot did not seem recently familiar with the B3e model and the options that were installed on the accident helicopter. The safety pilot asked a lot of questions about the B3e, and the [owner] pilot appeared more familiar with the helicopter systems than the safety pilot.
This may have course have been the safety pilot checking the owner pilot’s understanding. Although not mentioned by the NTSB, the survivor also commented that both pilots were aware of a past accident where an object in the cabin caught on flying controls and were very alert to that hazard.
During this trip the helicopter departed Juneau, Alaska that morning bound for Yakutat, Alaska. It proceeded west over the mountains st 3000-4000 ft AMSL, then north-west along the coast at about 500 to 700 ft AMSL.
Video from the cockpit image recorder [an Appareo Vision 1000] indicated that the pilot, seated in the right seat, was manipulating the flight controls from takeoff until the accident occurred [there is no mention of the NTSB of any analysis of the audio data recorded].
The surviving passenger stated that, while en route, the pilot indicated that they would be landing on a beach in order to stretch their legs.
The recovered data showed the helicopter flying about 500 to 700 ft over water when the pilots began conversing and pointing toward the shore. The safety pilot, whose hands were on his lap, then raised his right hand in a manner that appeared that he was guarding the cyclic control in anticipation that his assistance or intervention might be required. Shortly thereafter, the pilot twisted the collective twist grip throttle from FLIGHT to IDLE; data from the engine data recorder (EDR) indicated that, at this time, the engine fuel control was set to the idle power setting.
NTSB note that:
Such action is consistent with a practice autorotation.
NTSB data analysis shows:
The collective control was adjusted downward slightly, but the main rotor speed (Nr) gauge showed Nr decay from the normal “green” operating range of 375 to 405 rpm to the “yellow” cautionary range of 320 to 375 rpm about 5 seconds after the twist grip was set to IDLE. An Nr value of less than 360 rpm would have resulted in a continuous aural tone to alert the pilots of the low rotor speed.
About 7 seconds after the twist grip was set to IDLE, the pilot reached toward the center console, after which the “HORN” caution light illuminated, consistent with the pilot muting the aural tone signaling the low Nr condition. After the horn was muted, Nr continued to decay to a low of 254 rpm. Several small cyclic inputs were observed, then the recorded data ended.
[The survivor] heard the pilot yell “NO” and continue to manipulate the flight controls. He felt the helicopter impact the water and noticed water splash in the cabin before he lost onsciousness. He later awoke in the water and swam to shore, where he awaited rescue. He was unable to locate the other occupants.
Delayed Emergency Response
The NTSB state the accident occurred at 10:57 Local Time. No Emergency Locator Transmitter (ELT) signal was detected (one might suppose due to damage to the wiring between the unit and antenna, a sadly common failure in helicopter accidents).
The NTSB do not give further details of the emergency response in their report but local press reports state that the US Coast Guard were not alerted until 18:30 and a helicopter was not dispatched until 20:15, locating the boy about 2 hours later. The survivor was not surprisingly suffering from hypothermia.
Interview data in the public docket suggests the last satellite tracking signal was received at the safety pilot’s company at 10:51. They however assumed that the hand held Garmin inReach unit had not been charged sufficiently the previous night and so took no action until early evening when they realised the aircraft had not reached its destination for the day.
Postaccident examination of the helicopter and the recovered data did not reveal any helicopter malfunctions or failures that would have precluded normal operation.
Since recorded cockpit imagery did not capture microphone audio, the reason for the pilot’s decision to roll the throttle to IDLE could not be determined, and what conversations the pilots may have had before and during the maneuver could not be determined. The passengers’ headphones were muted from the pilots’ conversation, and the surviving passenger did not know if they planned to practice an autorotation to the beach.
Cockpit video recordings from previous flights indicated that the safety pilot did not guard the flight controls when the pilot was performing takeoffs or landings. It is plausible that the pilot’s intention was to practice or perform an autorotation to the beach, with the safety pilot guarding the controls. However, the beach was not the most suitable location for a practice autorotation to landing procedure and was out of the ordinary from their previous flights, as observed on the recorded cockpit imagery.
When the twist grip throttle is set to IDLE position during normal flight, Nr will decay unless the pilot takes action to maintain it, such as a reduction in main rotor collective pitch or returning the twist grip throttle to the FLIGHT position. However, after the throttle was set to IDLE, the pilot failed to reduce main rotor collective pitch, which resulted in low rotor rpm. The pilot’s action of muting the low rotor rpm alert horn indicated that he was aware of the annunciation to an anomalous condition, but it could not be determined if the pilot understood the nature of why the horn annunciated or the criticality of the situation.
NTSB Probable Cause
The pilot’s failure to maintain main rotor speed after setting the engine fuel control to idle, which resulted in a loss of helicopter control and impact with water.
Airbus Helicopters issued Safety Information Notice (SIN) 2896-S-00 (dated 7 July 2015) on simulated engine-off landing (EOL) training. The notice stated:
Current helicopter accident / incident statistics indicate that the greatest exposure to accidents or incidents is during simulated EOL. The purpose of this Safety Information Notice is to raise the level of awareness of Flight Instructors involved in simulated EOL training and to stress on key points.
It included recommendations that minimal crew be onboard during training, and that a power recovery be initiated as the helicopter passed through 200 ft agl. It also recommended:
- keep in mind that a higher All Up Weight increases the risk of NR overspeed and hard landing
- be prepared to conduct engine-off landing if power recovery is unsuccessful
- aft cyclic input during the ground slide will do nothing at all except chop off the tail boom
- for go-around maneuvers, anticipate the decision process.
That SIN also references: EHEST Leaflet HE 5 Risk Management in Training
You may also find these Aerossurance articles of interest:
- Inappropriate Autorotation Training: Police AS350
- B206B Hit by Truck in Forced Landing after 16 Months of Operation with Unairworthy Engine
- Latent Engine Defect Downs R44: NR Dropped to Zero During Autorotation
- AS350B3 Dynamic Rollover When Headset Cord Snags Unguarded Collective
- AS350B3 Rolls Over: Pilot Caught Out By Engine Control Differences
- Be Careful If You Step Outside!: Unoccupied Rotors Running AS350 Takes Off
- SAR Questions Feature in PNG AIC B427 Accident Investigation
- Hawaiian Air Tour EC130T2 Hard Landing after Power Loss (Part 1)
- Hawaiian Air Tour EC130T2 Hard Landing after Power Loss (Part 2 – Survivability)
- Helicopter Engine Unapproved Repair Leads to Forced Landing Damage
- US HEMS EC135P1 Dual Engine Failure: 7 July 2018
- EC135P2+ Loss of NR Control During N2 Adjustment Flight
- EC135P2 Spatial Disorientation Accident
- A Baffled Attitude Fuel Starvation Accident
- R44 Force Lands After Improper Repair
- Loose B-Nut: Accident During EC130B4 Maintenance Check Flight
- AAIB Report on Glasgow Police EC135T2+ Clutha Helicopter Accident
- Accident Report: Fatal Police Helicopter Double Engine Flameout Over City Centre
- Tree Top Autorotation for B206L1 After Loose Fuel Line B-Nut Leaks
- HEMS S-76C Night Approach LOC-I Incident
- AS350 Tail Rotor Control Incident, Grand Caymen
- Dim, Negative Transfer Double Flameout
- BK117B2 Air Ambulance Flameout: Fuel Transfer Pumps OFF, Caution Lights Invisible in NVG Modified Cockpit
- Wayward Window: Fatal Loss of a Fire-Fighting Helicopter in NZ
- When Habits Kill – Canadian MD500 Accident
- HF Lessons from an AS365N3+ Gear Up Landing
- Fatal R44 Loss of Control Accident: Overweight and Out of Balance
- Torched Tennessee Tour Trip (B206L N16760)
- UPDATE 2 July 2022: Fatal EC130B4 Water Impact in the Tennessee River after “Entry to VRS” Say NTSB
- UPDATE 27 July 2023: B407 Damaged During Autorotation Training